Getting My Antminer t9 control board To Work
Getting My Antminer t9 control board To Work
Blog Article
we'd alter the shipping and delivery charge if the desired destination place is just too remote; and likewise if require to change the delivery process possibly by sea or by air, remember to Make contact with us for the rate through [email protected];
Servicing staff are needed to have a specific amount of Digital awareness, with at the very least a single yr of upkeep working experience and skills in soldering systems including BGA, QFN, and LGA offers.
Be aware: this article is made up of frequent comparisons among the T21 for the S21. They ended up produced at the same time, so it only is sensible.
This will advertise the chip pins and pads to re-run, then the tin need to be taken off to achieve the outcome of re-tinning. If your failure persists right after re-soldering, the chip should be replaced specifically.
Disconnect the Old Control Board Thoroughly disconnect the 3x 18-pin sign cables, PSU electric power extension cable, voltage regulating cable, and 4x enthusiast cables with the old control board.
Effectiveness: Updates can Increase the mining performance of the components, bringing about better hash premiums.
The ARC Tester will help to determine malfunctioning chip around the board and might flash the EEPROM of hashboards without disassembling the miner.
Instructors must comprehensive at the least 4 hrs of training methodology courses. 8 several hours might be acquired as a result of these hours.
Following the chip is damaged, it'll result in the voltage domain to fall short. Because the voltage domain is in sequence, it's going to result in no voltage during the again-close voltage domain, plus the voltage area associated will prevent running.
given that the S21. Do they come from another bin of chips? When they are so comparable, why is there nevertheless a lot availability in T21 models when compared to S21 models?
Ahead of connecting it to your output on the Improve module, we must exam the constructive and negative poles of C1314 using a multimeter.
If 1.8V is usual, measure the bottom resistance of your test issue after the energy is Slice off and compare Using the Alright board to view if there is any resistance abnormality; In case the resistance value is ordinary, and there's no problem with soldering. This chip must have an issue.
Once the inventory is lower, We are going to deliver the common control board, many of the control board are going to be strictly analyzed to ensure the regular operation right before shipment.
Initiate Upgrade: Follow the typical firmware upgrade procedure through the Antminer z15 control boar miner's interface, ensuring no interruptions throughout the improve.